type: CWE-K
model: CWE-04-K
Load Capacity max.: 4.000 kg
Coil Outside Diameter max.: 1.600 mm
Coil Width max.: 800 mm
type: CWE-K
model: CWE-08-K
Load Capacity max.: 8.000 kg
Coil Outside Diameter max.: 2.000 mm
Coil Width max.: 1.000 mm
type: CWE-K
model: CWE-12-K
Load Capacity max.: 12.000 kg
Coil Outside Diameter max.: 2.100 mm
Coil Width max.: 1.000 mm

Electrically operated Coil Tilting Tables

The Classical Ones with electric Drive

Standard Versions as well as Special Versions


The electrically driven coil tilting tables, offered by Seidel Handlingsysteme GmbH, mainly consist of a solidely welded machine body plus a very stable base. The electrically operated drive is integrated into the base and powers two extremely stable chains, which move the tilting unit between the horizontal and vertical final positions. During this the tilting unit is moved on 4 high-quality bearings.   

The tilting unit itself is welded out of precisely produced steel parts with additional reinforcers. One side of the tilting unit does have a prism for pick up of the coil in vertical position, the other side does have a horizontal plate, for pick up of a coil in horizontal position, lying on a pallet or on cross beams. This side, in the middle, additionally does have a cut-out, so that the coil standing on the prism will be easily accessable for being taken away by crane or coil transport cart.   

The distance between the prism and the plate, which is standing opposite to the prism within 90° angle, is big enough to put into or take out of this space a pallet or cross beams after having tilted the coil. 
Small coils will be protected against dropping down by safety rods or optionally by safety swords.

Electrically operated coil tilting tables mainly are used within the range of coil weight between 10 to 15 tons, but also are available for smaller or bigger coil weights. They are available for coil widths up to 1.500 mm as well as for 2.000 mm coil outside diameter. Coil tilting tables for bigger coil dimensions also can be offered upon request.

Electrically driven coil tilting tables do not need foundations or floor bolting.

As far as the coil tilting table is equipped with a "2-hand-control" it also is allowed to be used without safety fence. This saves a lot of space at the place of installation. The maximum allowed speed of a coil tilting table with 2-hand-control is more slowly than the allowed speed of a coil tilting table with safety fence installation, due to safety regulations. The coil tilting tables listed here are available with or without safety fence installation.

We also can supply coil tilting tables for much bigger load weight than shown on this page. Please let us have your inquiry.  


If you will have questions regarding our electrically operated coil tilting tables, we will be at your disposal at any time for answering. Please do not hesitate to contact us:

Seidel Handlingsysteme GmbH

Phone:  +49 2156 419193
Fax:  +49 2156 4979325
Email:  info@seidel-handlingsysteme.de


 

flat bed_vehicles large sized_reels Hand Mover ground conveyor PTT3 with lifting hydraulics Schwerlasthandling Turners for heavy Components gripper feed with pilot valve coil_transport_cars Werkzeugwechsel sheet_metal_straightening_machines RSTL Werkzeughandling Press Die Splitters pedestrian_push_pull_units_PTT3